![]() OK, the RFID library is ready for this project. sudo apt install python3-dev python3-pip.At this point, the Raspberry Pi board must be connected to the Internet. First, open the terminal and run the following commands one by one. ![]() Ok, now let’s install the RFID library into Raspberry Pi OS. Then, connect the GPIO ribbon cable to the Raspberry Pi board and provide a power supply to the board. Now, connect the keyboard, mouse, monitor, ethernet cable, and SD card(OS installed) to the Raspberry Pi board. Also, connect the LCD and relay module to the extension board. And then, connect it to the extension board. Next, place the buzzer on the breadboard. Thirdly, connect the RFID module to the GPIO extension board. And then, connect the GPIO ribbon cable to the extension board. Secondly, connect the GPIO Extension board to the breadboard. ![]() Raspberry Pi board RDIF module Relay module GPIO Extension board LCD screen I2C module Breadboard Buzzer GPIO Ribbon cable Male to Female jumper wires Male to Male jumper wires
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |